ThermalCapture Smart+ User Manual
description of pins.:
1
5V supply for GPS
2
NC
3
NC
4
V+
5
GND
6
Trigger_Out Connects the Servo Connector
signal to the Trigger_In of
TCFusionZoom
7
GPS_Out forwards GPS data to
TCFusionZoom
T h e
Trigger_Out
pin forwards a PWM signal from the
Servo Connector
of
to the
Trigger_In
pin of
TCFusionZoom
. On Pin1 is the supply for an optionally TeAx-GPS-Module
connected to the TeAx-GPS-Connector (supply of GPS by
TCFusionZoom
). Via Pin7 GPS_Out the
GPS data from an optionally available TeAx-GPS-Module are forwarded to the GPS_In of
TCFusionZoom
.
2.2.9 Micro HDMI
This Micro HDMI port provides a standard HDMI output. You can connect every standard HDMI
monitor or TV. It’s intended for developing directly on the target system. The system should be able
to detect the correct resolution of the monitor via EDID information. To be on the safe side connect
the monitor before starting the system. Please remember that you can always access the system
via ssh if something went wrong and the monitor is not detected correctly. Tools like
xrandr
and
derivatives can be useful to explore the available monitor devices.
2.2.10 USB3-Port
provides a USB 3.0 connection for devices with high bandwidth needs (Bus 03 Port 1 in
listing below). It’s fully downward compatible to USB 2.0 and USB 1.0. Ideally connect
TCFusionZoom
to this USB port.
ubuntu@ubuntu:$ sudo lsusb -t
/: Bus 03.Port 1: Dev 1, Class=root_hub, Driver=tegra-xhci/2p, 5000M
/: Bus 02.Port 1: Dev 1, Class=root_hub, Driver=tegra-xhci/6p, 480M
|__ Port 2: Dev 3, If 0, Class=Vendor Specific Class, Driver=, 480M
|__ Port 2: Dev 3, If 1, Class=Vendor Specific Class, Driver=, 480M
/: Bus 01.Port 1: Dev 1, Class=root_hub, Driver=tegra-ehci/1p, 480M
10 / 17
