![TeAx Technology ThermalCapture Grabber USB Series Mounting Instructions Download Page 6](http://html1.mh-extra.com/html/teax-technology/thermalcapture-grabber-usb-series/thermalcapture-grabber-usb-series_mounting-instructions_4009376006.webp)
ThermalCapture – Mounting
Step 4: Mount the ThermalCapture board
For this step you need the ThermalCapture board, 2x M1.6x6mm (at blue arrows) and 1x
M1.6x10mm (at green arrow) screws, 2 isolating washers (2mm) and the small distance
sleeve from the screw set.
Stick the screws through the marked holes and apply the distance sleeve to the screw at
the green marked position. The distance sleeve must be added between the board and the
ground plate.
Connect the ThermalCapture board to the TAU core carefully. Do not apply strong forces.
Be careful especially with the both screws near the connector. Tighten the screws not
stronger than necessary to keep the board safely connected and in position. Tightening
these screws too strong may damage the TAU core or ThermalCapture.
6 / 9