13
7.2.1 Manual pairing method for sensors and Teasi Core
If sensors won’t connect automatically, you can connect them manually.
Make sure that the sensors have been activated for operation.
Speed & Cadence Sensor: The magnets must pass the sensor surfaces to activate the
sensor.
Heart rate sensor: Must have secure skin contact with lightly moistened contact surfaces.
Long press
for 2 sec and then release it after hearing the buzzer sounds twice, then the
Teasi Core will enter the mode to pair and connect with sensor; after the following
interface is shown, short press
to search sensor; when one sensor is searched, its name
will be displayed and the equipment will connect to it automatically. Short press
at this
time to start searching the next sensor. After the 2 sensors are searched, short press
to
exit sensor searching mode; if it only needs to connect to one sensor, long press
for 1
sec after searching, and then exit sensor pairing interface after hearing the buzzer sounds
once. Then, this following connection status symbol will be shown on the screen, showing
that Teasi Core has been successfully connected to sensors, and the bike computer can
start to work independently. However, the wheel size shall be set. See settings for wheel
size setup.
Teasi Core and sensors pairing interface Working interface entered after pairing is completed
In bike computer working mode, some data may not be displayed, for example, data is
displayed ——, the reason is that:
1. These data are all from the app, and the app is not connected when Teasi Core is working
independently, so there is no data source.
2. Speed/cadence sensor and heart rate monitor are not paired and connected to each
other,
so there is no data source.