16
17
English
English
power supply connection
Connect the radio to the power supply of the vehicle with the cigarette lighter adapter.
fuses
The power supply cable fixed to the LCmobile is equipped with one 15A/250V fuse. The
power supply cable that is connected with the power source contains two 20A/250V fuses.
Beware using the correct, according fuse. Damages to the radio can occur when using the
wrong fuse.
If the fuse blows, determine the cause, then solve the problem. After the problem is resolved,
replace the fuse. If newly installed fuses continue to blow, disconnect the power cable and
contact your authorized dealer or an authorized servicecenter.
1. Open the snap-in fuse case.
2. Remove the cable with the fuse out of the case.
3. Pull the cable ends with the attached fuse holder apart.
4. Replace the defect fuse, push the fuse into place - a click will be audible - and close the
fuse case.
external speaker
External 8 Ohm speakers must have a 3.5 mm plug which has to be connected to the speaker
connection (9). Beware of the length of the cable when determining the position.
microphone connection
Snap the modular RJ-45 plug of the microphone with the latching tab facing down into the
microphone jack (5) located on the front of the radio.
For protection, the plug has a rubber cover. To remove the plug, push the rubber cover on
the bottom to unlatch the tab and pull the plug out.
Please note that for transmission and reception, the microphone has be to connected.
FUNCTIONS
The LCmobile PMR can be programmed by TEAM or an authorized TEAM dealer.
The following settings and functions are available:
50 CTCSS / 777 DCS N/ I for rx- and tx-frequencies
selective calling DTMF / 2-Ton / 5-Ton
Busy Channel Lockout - transmission blockage on occupied channels
TX Off - transmission blockage
MR Channel - set initial channel after data transfer
Squelch Level
Time Out Timer - transmission time restriction
Auto Power Off
Voice Prompt - confirmation tone
G1/G2 - work group activation
Volume
Microphone Sensitivity
Tail Eliminator Type - signal improvement
DTMF
(Transmitting Time, Self ID, Group Code, Decoding Response, First Digit Time, Pretime,
Auto Reset Time, Time Lapse after Encode, PTT ID Pause Time, Side Tone, PTT ID Star-
ting, PTT ID Ending, Remotely Kill, Remotely Stun, DTMF Encodes)
2-Tone
(1st Tone Duration, 2nd Tone Duration, Long Tone Duration, Gap Time, Auto Reset Time,
Side Tone, encodes, 2Tone Call Format, Decoding Response, A- / B- / -C / -D-Tone
Frequencies)
5-Tone
(Self ID, Decode Standard, Time of Decode Tone, Pretime, Auto Reset Time, Time Lapse
after Encode, First Delay, Side Tone, Information ID No., Function Option, Decoding Re-
sponse, Information ID, Function Name, Encode ID)
Scan - Kanalsuchlauf
(Scan Mode, Priority Channel 1/2, Revert Channel, Look Back Time A/B, Dropout Delay
Time, Dwell Time, Scan Enter Tone)
