4
XXX-SCB ELECTRONICS SYSTEM OvERvIEw
PEAk DETECTION CHARGER
Peak detection chargers monitor the battery during charging and
automatically shut off upon full charge. You can either purchase a peak
detection charger that plugs into a household AC wall socket or one
that requires you to also purchase a 12V power supply.
If using a charger other than a peak detection charger, make sure
your battery is fully discharged prior to charging. Many of these have
a 15–20 minute timer that allows you to set a charge time. If the
battery is not fully discharged, you can potentially over-charge your
battery pack.
Do not charge any battery unattended
, and monitor
for heat build up. If the battery pack is more than warm to the touch,
immediately discontinue charging. Read all safety precautions
supplied by the charger and battery manufacturer.
SUPPLIED AND REQUIRED EQUIPMENT
Supplied tools
2-Way wrench
• Transmitter/Receiver BIND Plug
•
4 Hex Wrench “L” shaped
• Flat Turnbuckle Wrench
•
.050, 1/16, 5/64, and 3/32 • 4 AA Alkaline Batteries
-
Recommended Accessories
Hobby grade knife
• Needle nose pliers
•
Side cutting pliers
• Safety goggles
•
Soldering iron
• Double-sided tape (LOSA4004)
•
CA glue (LOSA7880 or LOSA7881)
•
Required Equipment
A 6- to 7-cell NiMH battery pack. Or with proper
•
knowledge, LiPo battery packs.
NiMH battery charger with automatic peak detection
•
recommended (LiPo charger if using LiPo battery).
F
G
C
E
D
B
A
H
A. LOSI MOTOR
B. EC3
™
BATTERY PLUG
C. LOSI MSC12L
D. SETUP BUTTON
E. STEERING SERVO
F. BIND PLUG
G. ON/OFF SWITCH
H. SPEKTRUM SPMSR300
