EN
4
TENACITY SCT RTR, AVC: 1:10 4WD SCT • INSTRUCTION MANUAL
1
2
3
4
5
6
7
8
10
11
9
12
13
INSTALLING THE BATTERY
INSTALLING THE TRANSMITTER BATTERIES
1. Push in the battery cover a small amount to release the retaining tab, then remove the cover.
2. Install 4 AA batteries, taking care to align the battery polarity to the diagram in the
transmitter’s battery case.
3. Carefully reinstall the battery cover by aligning the tabs with the slots on the transmitter.
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries.
Charging non-rechargeable batteries may cause the batteries to burst, resulting in
injury to persons and/or damage to property.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to national regulations.
For more information on the transmitter, go to www.horizonhobby.com and click
on the support tab for the Spektrum DX2E to download the instruction manual.
SRS6000 AVC TECHNOLOGY RECEIVER
Antenna
Bind/Battery
Aux 4/Disable
Aux 3
Aux 2
Aux 1
Throttle
Steering
AUX CHANNELS
The Aux channels can operate as additional servo channels, or as a power supply for a personal
transponder.
If AVC is active, only 4 channels; Steering, Throttle, AUX3 and AUX4 are operational. The
reaming Aux channels can be used to power a personal transponder or lights.
If AVC is disabled (see DISABLING THE STABILITY ASSIST FUNCTION), all 6 channels including
the Aux channels can operate as servo channels.
SPEKTRUM DX2E ACTIVE RADIO SYSTEM
1. Ensure the ESC is powered OFF.
2. Rotate the battery hatch lock to align the fl at section with the edge of the battery hatch.
3. Open the battery hatch.
4. Connect the battery to the ESC noting the correct polarity.
5. Install the fully charged battery in the vehicle.
6. Close the battery hatch and rotate the lock fully to secure the hatch.
7. Power ON the transmitter, then the vehicle.
IMPORTANT:
Secure the ESC wires so they do not interfere with the gearing.
1. Steering
Wheel
Controls direction (left/right) of the model
2. Throttle
Trigger
Controls speed and direction (forward/brake/reverse) of the model
3. BIND
Button
Puts the transmitter into Bind Mode
4. ON/OFF
Switch
Turns the power ON/OFF for the transmitter
5. TH.REV
Reverses function of the speed control when pulled back or pushed forward
6. Indicator
Lights
-
Solid green light
—indicates adequate battery power
-
Flashing green light
—indicates the battery voltage is critically low. Replace batteries
7. ST.
REV
Reverses the function of the steering when the wheels is turned left or right
8. ST
Trim
Adjusts the steering center point
9. TH
Trim
Adjusts the throttle neutral point
10. TH Limiter
Limits throttle output to 50, 70 or 100%.
11. 3-Position Switch
Used to control a third channel and is preset at -100%/Neutral/100%
12. ST Rate
Adjusts the sensitivity of AVC technology
13. Antenna
Transmits the signal to the model
