1
4
2
1
4
2
SAME FOR THE OTHER SIDE
Bolt the left wheel with the long screws provided.
Bag "D"
Differential axle assembly
1) Use the above ride-height adjusters to set the rear height of the car. The
adjuster you use depends on the rear tire size.
2) Push the flanged bearings from Bag "B" into the ride height
adjusters. Press the plastic adjuster into the bulkhead as shown.
3) Assemble the diff as shown. Use FSR/CRC white diff
grease on the balls. Tighten the nut so that the gear will
not slip when both left + right wheels are held.
Optional
-you can pin the right wheel to the diff
hub to ensure it does not slip
under high acceleration.
1) Install 2 small bearings from
Bag "B" in each front wheel.
2) Use an e-clip to fasten each wheel
to the axle.
Optional - Use CRC# 4114 Titanium
stub axles w/ locknuts to fasten each
wheel. These eliminate the e-clips.
6
Optional
- You may want to use a 4-40 set screw in the
diff hub to prevent the wheel from spinning on the hub
under hard accelleration. The hub is tapped 4-40.