To get access to the other end of the camera lead, remove the four hex screws from the underside of the
frame holding the POWERCUBE stack in place. Disconnect the lead from the CAM1 socket on the FPVISION
board. This is only necessary if you need to replace the camera lead. Replace the camera with a new unit.
Remove the two Phillips screws from the back of the camera and replace the backplate with the desired tilt
angle you prefer. Reassembly the unit, making sure not to get any dust particles on the image sensor.
Replacing motors
Use a hex screwdriver to remove the four screws on the underside of the frame arm. Loosen the fibertape
holding the bullet connectors to the frame.
21
