Page 10
Page 11
Empty the detachable bowl to a foul water drain and rinse with clean water.
If unit is left unused for an extended period it is recommended that it is emptied
of water and replenished with fresh water.
Clean all surfaces with an anti-bacterial wipe or disinfectant paying particular
attention to frequent contact points. To clean the inside of the bowl, first take off
the removable rubber cover.
Do not use abrasive cleaners which may scratch the external surfaces.
This unit must not be subjected to a high pressure water jet.
It is recommended that the unit is cleaned with a cleaning solution such as Milton
according to the instructions on a weekly basis.
Towel holder
ref
GENTWLHDR
Soap bottle and bracket ref
GENSOAPDISP/BRKT
Cleaning instructions
Optional extras
At the end of its useful life, the handwash unit should not be
disposed of in general household waste.
Units should be taken to a recycling facility for electrical and
electronic items.
Please see WEEE regulations.
All Teal Patents products are tested before leaving the factory.
The unit is covered by a two year return to manufacturer warranty from date of
purchase – please ensure that you retain proof of purchase.
Any faulty items will be repaired or replaced, and the repairs guaranteed for the
remainder of the original warranty period.
Exclusions
Teal Patents will not be liable to repair or replace goods where:
•
The fault has been caused through misuse, accidental damage, use contrary
to the manufacturers instructions, damage in transit or power surges.
•
The appliance has been used on a voltage supply other than that specified on
the product
•
Repairs have been attempted by someone other than Teal Patents or an
authorised dealer
•
The appliance is second hand
•
The warranty does not cover any claims for consequential loss or damage.
This guarantee does not effect your statutory rights as a consumer.
Guarantee
Disposal
No water dispensed.
Check water level in tank
Water cold.
Check Orange LED is on. If not, check power supply. If LED is on leave
unit for 15 minutes to fully heat water. If water is still cold unplug unit and return
to supplier.
Red LED solid.
Unit cut-out activated.
•
Low water.
•
Check water level. Refill if required and press and release reset button
•
Unit tilted.
•
Return unit to upright position. Refill if required and press and release
reset button.
Red LED flashing.
Hardware fault.
•
Unplug unit. Check water level and refill if required. Plug unit in. If fault
persists contact Teal or the retailer.
Water around unit.
Clean up any spillage from filling unit.
Check that the bowl is not full.
If further water is seen switch off unit and contact the supplier for advice.
Troubleshooting guide
