TEAL SPORT
User Guide
TEAL SPORT
User Guide
tealdrones.com
tealdrones.com
16
17
To fly the Teal Sport Bind and Fly model, first you must install the radio receiver and bind the
receiver to the radio transmitter so the transmitter knows which receiver it is talking to. The FRSky
Taranis QX7 and FRSky X4RSB receiver are the recommended hardware for the Teal Sport. Other
types and brands of receivers and transmitters can be used but the below instructions only show
how to install the X4RSB receiver used with the Taranis QX7 transmitter.
1.
Remove props (take note of direction/orientation before removing).
2.
Remove the eight (8) arm screws that hold the top plate. Remove top plate.
3.
Place X4RSB receiver on double sided tape.
4.
Connect receiver cable to receiver. The plug connects to the side of the X4R and the S.Bus
needs to be connected to the bottom pin, closest to the side plug. It is very important that
the correct pin is connected as damaging components may result if done incorrectly.
Figure 1
5.
Place receiver antennas along the inside of the drone chassis.
6.
To bind the receiver to the Taranis QX7, power on Tanaris QX7 transmitter and press the
middle menu button to access the menu.
7.
Press the center menu button, followed by the page button to get to the “Setup” menu. Scroll
down to “Bind” and press the scroll wheel to select it. The radio will beep every few seconds
indicating the Taranis is in bind mode.
Figure 2
INSTALLING X4RSB RECEIVER AND BINDING
X4RSB RECEIVER TO TARANIS QX7
8.
Hold down the bind button on X4R receiver and power up the quad by plugging in a battery,
while continuing to hold down the receiver bind button. The green LED will turn solid, the red
LED will flash indicating it has bound. After this has happened, you can release the bind button.
Select bind on the radio’s setup menu one more time to stop the Taranis binding process, now
that the receiver is bound. Cycle power by unplugging and replugging battery to check bind
process is successful. A solid green LED will confirm bind is correctly set up.
Figure 3
9.
Replace the top plate and install the eight arm screws.
10. Re-install props in correct rotation positions. Double check they are spinning the correct
directions.
Figure 1
Figure 2
Figure 3
Connect Receiver Cable to bottom pin,
closest to the side plug.
Summary of Contents for Sport
Page 1: ...TEAL SPORT USER GUIDE ...
Page 15: ...tealdrones com ...
