A
B
C
A
B
C
C12 Quick Start Guide page 2
SCREEN REMOVAL
Lower the conveyor until it is horizontal. Remove the 2 x
M12 bolts holding the screens in place. Fit the required size
of screens into the machine by removing the 4 x M12 bolts
either side of the screen. Please note the screen with the
larger holes should be placed on the left hand side of the
machine (facing forward). Withdraw the screen frame with
caution, and do no pull them past the guide.
6
AFTER WORK
Fold up the conveyor by extending the
bottom rams, then top ram until the conveyor
rubbers sit on the, transport brackets.
14
SCREEN STORAGE
The screens can be stored in the rack on the machine
which will hold 4 screens in total.
7
FIRST TIME RUNNING
With the Bluetooth light on, Turn the Control box ON.
When you turn the PTO on, it will run the conveyor.
The tub can be started by pressing the TUB FORWARD button
The Tub speed can be adjusted by the speed dial (0-10)
Select the automatic load sensing mode or the manual tub control mode
8
AUXILARY STOP SWITCH
If pressed this wills top the tub instantly
& stop the conveyor belt a few seconds later.
9
FLASHING BEACON
Flashing Beacon– indicates the rotor is under
load and slowing down while chopping
straw. It also flashes when the rotor is
running down, to inform people not to jump
into the tub when the rotor is spinning.
10
SPECIAL FEATURES
If the auxiliary stop switch is pressed, all
the lights on the control box will illuminate
and flash at the same time. Twist the head
of the switch to release and to return to
normal operating mode.
11
REGULAR MAINTENANCE
Consult the manual for the complete
maintenance instructions.
13
Before road transport, blow off excess
straw dust from the machine to avoid the
dust impairing other road users vision.
Clean the oil cooler regularly with air.
MAIN ROTOR BELT TENSION
If the main rotor drive belts start to squeal, wait for the bale to finish and the rotor to stop, then re-tension & re-start the PTO.
12
