TOMAHAWK FAULT FINDING CHART – PART 2
Symptom
Fault
Possible Solutions
Shear bolt fails
repeatedly.
Bolt bushes worn or damaged.
Replace with new bushes.
Tailgate raised too high forcing bale into
crossbeater(s).
Lower to tailgate allow material in bale chamber to
rotate freely.
Front half of large rectangular bale not
rotating freely.
Lower the tailgate to allow material in bale chamber
to rotate freely and increase the bed chain speed to
encourage rotation of the front half of bale.
Single beater
shear bolt fails
repeatedly
Gap between bale finger and crossbeater
ring too great.
Adjust bale finger to give 3mm clearance on blade
ring on beater.
Twin beater
shear bolt fails
repeatedly
Long dry silage wrapping around
crossbeater(s) and bale restraint.
Consult manufacturer.
Chute and
rotor blocks
Chute exit blocked.
Make sure material can leave the chute freely.
Rotor speed low.
Check that slip clutch is not slipping - indicated by hot
clutch assembly. Also Increase engine speed.
Swivel giraffe
chute blocks
Material not flowing smoothly.
Raise deflector to improve flow and rotate chute to
achieve desired delivery position.
Rotor speed low.
Check high rotor speed selected on gearbox.
Hydraulic
valve fails to
operate
Hydraulic connections to tractor faulty or
not connected.
Rectify making sure pressure is applied to the valve
via the supply hose and that the return line flow is not
restricted.
Bed chain no
longer
operates or
only very
slowly. Failure
may be
sudden or
intermittent.
Dirt or contamination in the Bypass Valve
or the Pressure Relief Valve in the flow
control slice.
Firstly, remove the Bypass Valve from the Flow
Control Slice inspect for contamination clean and
replace. If problem still exists, remove the Pressure
Relief Valve and inspect for contamination. If
problem persists or re occurs regularly replace tractor
hydraulic oil with new clean oil.
Loss of
operation of
rams and
swivel slices.
Also operation
of bed in only
1 direction
may occur.
Failure may be
sudden or
deteriorate
slowly over a
few days.
Oil leaking from between slices of the
valve.
Internal failure in valve
See section below.
Contact manufacturer for advice.
Internal pressure in valve.
Check return line hose connected and that return line
flow is not restricted by damaged fittings or the
tractor spool valve
Clamping bolts loose.
Check bolts through valve tightened to correct torque
specified in the maintenance section.
Interface seals damaged by either of the
above.
Replace damaged seals.
Oil leaking
from between
slices of the
valve.
12
Summary of Contents for Tomahawk 8080
Page 34: ...32 HYDRAULIC HOSES ...