Page
10
Use the remaining hydraulic system
from Steps 1-6 (the 13mL cylinder
connected to the 4.5mL cylinder)
and insert the two dowels into the
holes of the 4.5mL cylinder.
Use a cable tie to attach the
cylinder’s piston to the dowel
with the sliding block.
Place two blocks on the ends of the
60mm (2 ⅜″) dowels to complete the
gripper.
Cut the last two holes off the
connector strips of the second boom.
Use a screw and nut to attach the
gripper to the second boom.
Cut the pegs off the loose cylinders
and use #10 1″ screws and #10 nuts to
attach the cylinders together to form a
control panel.
Summary of Contents for Hydraulic Arm
Page 2: ...Page 1 ...
