6
V
Placement precautions
o
Do not install this unit in a location that could become hot.
This includes places that are exposed to direct sunlight or near
a radiator, heater, stove or other heating equipment. Moreover,
do not place it on top of an amplifier or other equipment that
generates heat. Doing so could cause discoloration, deformation
or malfunction.
o
Avoid locations that are extremely cold or exposed to excessive
humidity or dust.
o
When installing this unit, leave a little space (at least 3 cm or 8
"
)
between it and walls and other devices in order to allow good
heat dissipation. If you put it in a rack, for example, leave at least
5 cm (2
"
) open above it and at least 10 cm (4
"
) open behind it.
Failure to provide these gaps could cause heat to build up inside
and result in fire.
o
Place the unit in a stable location near the audio system that you
will use with it.
o
DO NOT place anything, not even CDs, CD-Rs, LP records or cas-
sette tapes, on top of the units. Doing so could cause damage.
o
The voltage supplied to the unit should match the voltage
printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
o
Do not move the unit during use.
o
Do not open the body of the unit because this could result in
damage to the circuitry or cause electric shock. If a foreign object
should enter the unit, contact your dealer.
o
When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.
Before use
Note about pinpoint feet
High-precision metal pinpoint feet are attached firmly to the bot-
tom plate of this unit.
The stands for these feet are loose, but when the unit is placed in
position, it is supported by these pinpoint feet, which will effectively
disperse vibrations.
Chassis
Pinpoint foot (metal)
Foot-stand (metal)
Screws that attach foot-stand
o
Apply the included pads to the bottoms of the foot-stands to
avoid scratching the surface where the unit is placed.