Z
4
Installation guide for the TEAC ASIO USB DRIVER
5
Click the Advanced tab.
If the Default Format is set to “384000 Hz”, click the right end of
this setting to open a pull-down menu and select any sampling
frequency of 192000 Hz or less.
Some software might not function properly if the sampling fre-
quency is set to a value higher than 192000 Hz.
o
After changing this setting once, “384000 Hz” will not appear
again.
6
Click “OK” to confirm the setting.
Music playback software settings
To output audio from music playback software from this unit when
connected to a computer by USB, set the sound playback device to
“TEAC USB AUDIO DEVICE“ in the settings of the software that you
are using.
See the instructions for that software for details about how to set the
sound playback device.
If the software does not have a sound output device setting, usually
sound will be output from the device selected as the Default Device
set for Windows sound playback as described above.
o
If you only want the sound from specific software to be output
from this unit, select “TEAC USB AUDIO DEVICE” in the settings
of that software, but do not set “TEAC USB AUDIO DEVICE” as
the Default Device for sound playback in the Windows Sound
Control Panel.
TEAC ASIO USB DRIVER Release Notes
Ver 1.0.10
o
When not using the ASIO Driver for playback, for example when
using Windows Media Player or iTunes, pausing or starting play-
back at certain times could cause noise in the playback sound.
This has been fixed.
o
Windows 10 compatibility has been confirmed.
o
The NT-503 and HR-X101 (CR-H101) have been added as sup-
ported devices.
Ver 1.0.8
o
We have responded to an issue with the appearance of the TEAC
ASIO USB DRIVER Control Panel during 11.2MHz DSD playback.
o
Due to a digital signature update, support for the Windows Vista
OS has been discontinued.
Since the only issue corrected was the above display issue,
Windows Vista users should install version 1.0.6.
Ver. 1.0.6
o
Support was added for 11.2MHz DSD playback using the UD-503
model.
Ver. 1.0.3
o
The UD-301 and AI-301DA are now supported.
Ver. 1.0.2
o
When connected to a USB 3.0 host controller made by Renesas
(NEC), the supported products would not be recognized prop-
erly in some cases. This has been fixed.
o
When the driver is installed on Windows 8, Windows 7 or
Windows Vista, the “Default Format” bit rate and sampling rate
settings in the sound playback device properties for the TEAC USB
AUDIO DEVICE are now 24-bit/192000 Hz.
For more about this setting, see Step
5
in “Setting the audio
output device” on page 4.
0716 MA-1893F
