EN
G
LI
SH
15
D
USB port (USB B type)
The sound of the record is converted to digital (resolution
up to 48 kHz/16-bit) and output. Recording on a com-
puter is possible by connecting this to a USB port on the
computer using a USB cable (page 16).
E
DC input connector
After completing all other connections, connect the
included AC adapter (GPE053A-V120050-Z) to this
connector.
Confirm that the power plug of the AC adapter is
plugged into a power outlet.
o
Unplug the power cord from the outlet when you are
not planning to use the unit for an extended period
of time.
o
Do not use any AC adapter other than the one
included (GPE053A-V120050-Z).
V
Be sure to connect the power cord to
an AC outlet that supplies the correct
voltage. Connection to an outlet that
supplies incorrect voltage could cause
fire or electric shock.
V
Hold the power plug when plugging it
into an outlet or unplugging it. Never
pull or yank on the power cord.
V
Unplug the power cord from the outlet
when you are not planning to use the
unit for an extended period of time.
F
STANDBY/ON button
Press the STANDBY/ON button to turn the unit on or put
it in standby.
Basic operation
Playing records
1
Press the STANDBY/ON button on the
back of the unit to turn it on.
2
Open the dust cover slowly.
V
Be careful not to pinch your hand, for
example, when opening and closing the
dust cover.
3
Raise the cartridge protector.
Protector
4
Place a record on the turntable (platter).
When playing a 45 RPM large-hole single record, use the
included adapter.
5
Select the rotation speed indicated on
the record.
The rotation speed can be set to 33 1/3, 45 or 78 RPM.
6
Turn the START/STOP rotation knob to
START to start the turntable (platter).
o
When the START/STOP rotation knob is set to START,
the turntable (platter) will start rotating and the blue
START lamp will light.
7
Slide the tone arm clasp to the right to
remove it.
Clasp
A
N
T I
– S K A T IN
G
3
0
8
Raise the arm lifter.
Tone arm
Arm lifter
A
N
T I
– S K A T IN
G
3
0
o
You can also move the tone arm to above the record
without raising the arm lifter and then slowly lower
the tone arm to start playback.
9
Move the tone arm to the track where
you want to start playback.
10
Lower the arm lifter.
Lower the tone arm slowly until the stylus touches the
record and playback begins.
o
Close the dust cover during playback. Doing so
reduces the occurrence of noise by preventing skip-
ping caused by unintended contact and blocking
external sound pressure.
V
Do not place anything on the dust cover.
ATTENTION
o
During playback, do not touch the tone arm or the record.
Doing so could damage the stylus tip and cause scratches
on the record.
o
Do not forcibly stop turntable (platter) rotation during
playback. Since this product is not a turntable designed
for DJs (direct drive), doing something like this could cause
malfunction.
During record playback, feedback could occur if the vol-
ume is too loud. If this happens, lower the volume of the
amplifier.
