13
1-6. Home Screen
The indicator value or graph display is shown after the unit is
turned on. (The last open screen will reappear.)
Use the
g
and
t
buttons to change screen views.
ATTENTION
The screen will open about 6 seconds after the unit is turned
on.
1-6-1. Indicator value screen
a b
c
d
e
f
g
h
i
j
k
l m n o
p
a
Number of recorded indicator values
This is the number of recorded indicator values (page
17).
b
Number of recorded graphs
This is the number of recorded data graphs (page 18).
c
Current time
See “10-9 Date & time setting” on page 59 for details
about the date display format and time and date settings.
1. Names and functions of parts
d
Power status
: Operating on bus power from the USB port.
: Operating on batteries
o
When the battery indicator becomes red,
the batteries are almost out of power. Stop
using the unit, and change the batteries. If
the batteries run out of power while data
is being written, the saved data might
become unreadable.
e
Hold Function Setting
This is the currently selected hold setting (page 46).
f
Indicator value
g
Low limit value
This is the set low limit value (page 43).
h
Setting value memory
SENSOR
Selected sensor value memory number (page 16)
SETTING
Selected setting value memory number (page 16)
i
Judgment type
HI
This lights to show high limit judgment for indicator
values higher than the setting value.
OK
This lights to show OK judgment when the indicator
value is equal to or higher than the low limit and
equal to or less than the high limit.
LO
This lights to show low limit judgment for indicator
values lower than the setting value.
NOTE
Judgment display operation changes according to the
Comp. Pattern, Comp. Output Pattern and Hysteresis
settings.
The above example is of operation when the Comp.
Pattern setting is LO/OK/HI, the Comp. Output Pattern is
“Standard Output” and the Hysteresis setting is 0.
