POWER SUPPLY
Using AC Power
1 . Check if the power voltage, as shown on the type plate located on the back of the set,
corresponds to your local AC power supply. If it does not, consult your dealer or
service centre.
2 . Connect the power cord to the AC MAINS inlet and the wall outlet .
The power supply is now connected and ready for use.
3 . To switch off completely, unplug the power cord from the wall outlet.
• Unplug the power cord from the wall outlet to protect your
set during heavy
thunderstorms.
• If the electric cable is damaged, it must be replaced by the manufacturer, or by the
qualification persons, in order to avoid danger.
7
DESCRIPTION
iPod/iPhone operation
TROUBLESHOOTING
CONNECTIONS
SPECIFICATION
Apps operation with iPhone/iPod
The remote control operates on one CR2025 battery (included).
To activate the remote control, remove the insulation tab inserted in the battery
compartment.
When the operation of the remote
control becomes intermittent or unsatisfactory,
replace the original battery with a new 3-volt lithium battery.
1.) Slide out the battery holder from the remote control case.
2.) Replace the 3V CR2025 battery. Be sure the battery is installed correctly.
The remote will not work if the battery is installed with the wrong polarity.
CAUTION: Danger of explosion if the battery is replaced incorrectly.
Replace only with the same type battery.
3.) Insert the battery holder back into the battery slot.
NOTE: Only use a well-known brand of cell battery to ensure the
longest life and best performance.
