Teac ER-LXRC1000, Instructions For Use Manual

Page: 30 / 40

30
EDGE
This sets the timing for counting pulses.
THRESHOLD
This sets the voltage level for counting.
DIV. RATIO
This sets the division ratio when dividing before
counting pulses. Set to 1 to not divide.
MOVING AVG. NUM.
This sets the number of data to use for the moving
average. Set to 1 to not use a moving average.
RANGE
Select the measurement range.
o The units shown depend on the mode selected.
PPR
This is shown when the mode is set to RPM.
Set the number of pulses per revolution.
8-3-4. GPS SETTINGS
Set when using the optional GPS receiver (LXGPS18X
(5Hz)).
USE
Select ON to use the GPS.
BAUD RATE
Set the transmission speed between the LX-1000 and
the GPS. Set this to 19200 usually.
DATA RECORD
When ON, GPS location information will be recorded
in recording data.
TIME ZONE
Set the time zone for showing the time.
To set a time zone other than Japan or UTC, select
USER.
TIME DIF.
When TIME ZONE is set to USER, set the time differ-
ence from UTC.
ADJUST TIME
Use to set the LX-1000 clock to the GPS time data.
o
To set the time without using GPS, input it using
the SET TIME item on the MISC screen (page 34).
GPS INFORMATION
If the STATUS is “NG”, a GPS unit is not connected or
no signal is being received from a satellite.
If the STATUS is “OK”, the GPS data being received will
be shown.
o
The
8
icons show the number of satellites being
received.
8. Settings