Teac crx-230, Owner'S Manual

Page: 2 / 5

Power connection
1. Plug the AC 2
4
0V Power Cord into an AC
household outlet.
2. If you want battery back up, insert one
alkaline 9V battery (not included) into the
battery compartment on the underside of the unit.
3. The batteries will remember the time during a power cut, but not display it.
4. Normal display and function will resume
when power is restored, replace the batteries annually.
5.
NOTE : No battery is needed for normal operation.
The mains plug is used as the disconnect device and it shall remain readily operable.
Switching the unit off does not disconnect it from the mains.To be completely disconnected,
To be completely disconnected, the mains plug of apparatus shall be removed from the mains.
A
s the disconnect device is the mains plug.
When the display gives no color, the apparatus is completely disconnected from
mains. NOTE:No battery is needed for normal operation.
6.
POWER SOURCES
PLAYER MAINTENANCE
Cleaning the Cabinet
IMPORTANT: Disconnect from Main Supply Before
cleaning.wipe with a soft cloth. If the cabinet is very
dirty, dampen the cloth with a weak solution of neutral
detergent and water, and then wipe clean.
Cleaning the Lens
A dirty lens may cause the sound to skip and, If the
lens is very dirty, the CD may not work. Open the
disc cover and clean the lens as follow:
Dry Dust Particles
Using a camera lens brush/blower, blow on the
lens couple times, then wipe it lightly with
the brush to remove dust. Then, blow on the lens
once more.
Finger prints
If the lens cannot be cleaned by using a brush/
blower use a dry cotton swab.
GB-2
DISC CLEANING, POWER FAILURE
Cleaning the Disc
1.To handle a disc use only one of the two
manners.
Note: Do not touch the rainbow colored side.
2.To wipe a disc, use only a soft cloth. Do not
use benzene or thinner which will damage the
disc, the disc should always be wiped in a
straight line from the centre to the edge. It
should never be wiped in a circular motion.
3. Never place the disc on other equipment or
near any heat source. Avoid positions where
the disc would be subjected to direct sunlight
for long periods.
Power failure
When AC power is interrupted, both time
and alarm settings will be lost (unless 1 x
6F22
battery (not supplied) is installed)
after power is restored. The digital display
will blink to show power was interrupted.
You must reset time and alarm times.
Battery back up
To keep alarm and time of day settings in
memory during a brief power failure or
accidental removal of AC cord from mains
socket, install 1 x
6F22
battery (not
supplied) into the battery compartment
on the underside of the unit.
Maintenance and care
１ ．
Electronic products should never be
subjected to extreme temperatures nor
high humidity to ensure good performance
and a long life-time.the clock radio should
not be placed in bathing areas, or around
stoves and radiators, etc.always leave
sufficient space around the unit for
ventilation.
2. If necessary, only clean the cabinet of
the unit with a soft dampened piece of
cloth, (be sure the AC power cord is
unplugged from the outlet).never use a
polish or a strong detergent for cleaning
since this can damage the finish of the
cabinet.
3. If the electric cable is damaged, it must
be replaced by the manufacturer, or by
the qualification persons, in order to
avoid a danger
GB-3