38
Troubleshooting
If the power supply is interrupted for 14 days or longer, all the
settings kept in memory (such as preset stations and timer settings)
will be erased.
It will take more than 3 days after plugging the power cord into
the outlet to charge enough electricity for the memory backup
function.
If you want to manually initialize the settings, hold down
the SOURCE button and play/pause (
y
/
J
) for more than 4
seconds in standby mode.
The unit will be turned on, and all the settings are reset to the
default settings.
In case of trouble with the unit, please take the time to look through
this chart and see if you can solve the problem yourself before you
call your dealer or TEAC service center.
Amplifier
No power.
e
Check the connection to the AC power supply.
No sound from speakers.
e
Check the connection to the speakers.
e
Adjust the volume.
e
Select proper source.
e
Pull out the headphones plug from PHONES jack.
e
If muting is on, press the MUTING button.
The sound is noisy.
e
The unit is too close to a TV set or similar appliances. Install the
unit apart from them, or turn them off.
Clock goes wrong.
e
The clock setting will not be saved when the POWER turns off.
Do not turn off the POWER switch on the front panel.
Remote Control Unit
Remote control unit does not work.
e
If the batteries are exhausted, change the batteries.
e
Use remote control unit within the range (5 m) and point at the
front panel.
e
Clear obstacles between the remote control unit and the main
unit.
e
If a fluorescent light is near the unit, turn it off.
Tuner
Cannot listen to any station, or signal is too weak.
e
Tune in the station properly.
e
If a TV set is near the unit, turn it off.
e
Install the antenna again after locating the best reception
position.
e
An external antenna is recommended.
Though the broadcast is stereo, it sounds monaural.
e
Press the FM MODE button.
DAB tuner
No sound.
e
Ensure that the unit has been able to locate DAB stations.
“NO stations Available” appears on the display.
e
Check that the DAB antenna is connected (see page 6).
e
Ensure that DAB broadcast covers your area.
Cannot access secondary services.
e
Not all services are accompanied by secondary services. If a
secondary service is available, the secondary indicator (“>>”) is
displayed next to the station name.
Display goes out or displayed “service off air”.
e
This may occur if a broadcaster changes the label of a service
or removes the label whilst you are listening to it. The unit will
try to retune to this station. If the problem persists, follow the
procedure for channel scan on page 27.
Restoring factory settings
