16
Basic Operation 1
Press the POWER switch.
The unit enters standby mode, and the standby indicator
lights.
1
Press the STANDBY/ON switch to turn the unit on.
The standby indicator goes off.
2
Select a source by pressing one of the INPUT SELECTOR
buttons.
3
The selected source is shown on the front panel’s display.
Each time the AUDIO button is pressed, the source changes
as follows:
Each time the VIDEO button is pressed, the source changes as
follows:
<
If one of the INPUT SELECTOR buttons is pressed in the
standby mode, the unit is turned on with the selected source
automatically.
<
If the source is connected to 6CH DIRECT INPUT jacks, press
the 6CH DIRECT button and proceed to step .
5
VIDEO 1
VIDEO 2
VIDEO 3
TUNER (Frequency is displayed.)
CD
AUX
Tape Monitor Function
If you want to select the source connected to TAPE MONITOR
jacks, press the TAPE MONITOR button to turn the tape
monitor function on. “TAPE M” indicator lights.
Press the TAPE MONITOR button again to cancel the tape
monitor function.
<
When the tape monitor function is on, sources other than
TAPE MONITOR cannot be heard. Be sure to turn the function
off while listening to other sources.
<
If the 6CH DIRECT button is pressed, the tape monitor
function will be automatically set to off.
<
If a 3-head cassette tape deck is connected to TAPE MONITOR
(PLAY and REC) jacks, and if the tape monitor function is set
to on during recording, you can listen to not the source
sound but the sound being recorded.
When you selected VIDEO (1, 2 or 3) or CD in step ,
press the DIGITAL INPUTS button repeatedly to select
the terminal.
3
4
o1:
Select this when the source is connected to DIGITAL IN
(OPTICAL) terminal.
c1:
Select this when the source is connected to DIGITAL IN
(COAXIAL 1) terminal.
c2:
Select this when the source is connected to DIGITAL IN
(COAXIAL 2) terminal.
A:
Select this when the source is connected to analog AUDIO
IN jacks.
<
The digital input display blinks when the unit cannot perceive
the digital signal. In that case, connect a digital device to the
DIGITAL IN terminal, switch it on, and select the terminal by
pressing the DIGITAL INPUTS button.
<
You can hear the sound from the selected DIGITAL IN
terminal as far as VIDEO (1, 2 or 3) or CD has been selected in
step .
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob.
5
3
standby indicator
2
1
3
4
5
