408-35043
Rev
D
20
of 30
Adjusting the feed position
NOTE
It is not necessary to remove air pressure from the air feed module before making a feed adjustment.
1. Extend the feed fully.
2. Retract the feed fully. The terminal should be positioned over the anvil.
3. If the terminal is not over the anvil, turn the feed adjustment screw (Figure 19) to reposition the
terminal (Figure 16).
If the terminal stops before the anvil (underfed), turn the screw clockwise.
If the terminal is past the anvil (overfed), turn the screw counter-clockwise.
NOTE
One click of the feed adjustment screw equals 0.025mm (0.001 inch) of adjustment. Make small adjustments before checking
the feed.
4. Retract the feed slide and terminals by pulling back on the terminal strip.
5. Extend the feed slide to feed a terminal.
6. If the terminal is not centered properly, repeat step 3.
Figure 19: Feed adjustment screw
1
Feed
arm
2
Feed adjustment screw
