408-35043
Rev
D
10
of 30
2.4.
Applicator with Pacific head
The Pacific applicator works only if the machine
’s
ram falls within the envelope shown in Figure 11.
(Dimensions are in millimeters, with inches in brackets.)
Figure 11: Ram dimensions for use with Pacific applicator
3.
INSTALLING AND REMOVING THE APPLICATOR
Disconnect electrical power when performing maintenance or repair on this equipment.
Disconnect air supply when performing maintenance or repair on this equipment.
DANGER
To avoid personal injury, use the applicator
only
in an appropriate terminating machine. Do not connect the pressurized air
supply until after the applicator is properly installed.
CAUTION
With the applicator in the machine,
do not
attempt to cycle the machine under power unless the terminals have been properly
loaded, as described in section 4. Doing so can damage the tooling.
NOTE
Remove the ram transportation collar after installing the applicator on a machine. Do not reinstall the ram transportation collar
until you are ready to remove the applicator from the machine.
