408-35253
Rev
A
2
of 5
NOTE
The terminal locator assembly maintains the terminal position during the crimping process. It is supplied pre-assembled to the
crimping die.
3.
INSTALLING THE DIE ASSEMBLY
For information concerning die installation, removal and general performance of each modular tool holder, refer
to the applicable 408 series instruction sheet packaged with the tool holder (Table 1).
DANGER
To avoid personal injury,
always disconnect
electrical and air supply from the power unit before installing the die assembly
into the tool holder.
To achieve proper orientation of the dies during installation, ensure that the alignment dots are facing in the
direction of the wire clamp on the modular tool holder (Figure 2).
Figure 2: Alignment dots
1
Alignment dots
2
Wire clamp
