TE-Group BTST, Instruction Manual

Page: 8 / 36

-GB-8- -GB-9-
ALERT TYPES
! Very quick beep rate instantly =. Full. Warning.. A.
Radar.or.Laser.source.has.suddenly.been.switched.on.
! Starts to beep slowly, then increases in rate rapidly
=.Full.Warning..Probably.Police.Radar.
! Beeps once or slowly and infrequently . =. Most.
likely a ‘False’ alert caused by a weak Radar signal.
However,. you. should. still. exercise. caution. in. case. it.
is.a.distant.signal.from.a.mobile.trap,.which.is.being.
switched.on.and.off.
Pulse Protection is more difficult to detect than a
normal. radar. because. it. remains. “off”. until. activated.
to.measure.the.speed.of.a.targeted.vehicle..When.a.
pulse.type.transmission.is.detected,.the.BTST.detector.
sounds.an.urgent..second.pulse.alert..The.standard.
alert.pattern.then.continues.for.as.long.as.the.signal.
is present. It is vital to respond quickly to a pulse alert
(hence.the.distinct.urgent.pulse.alert).as.warning.time.
may.be.minimal.
SELECTING BANDS
We.recommend.using.your.BTST.in.the.default.mode..
However,.to.select.between.different.radar.bands,.you.
should hold down ‘CITY’ for 2 seconds. The display
will then show the current settings. Use the ‘MUTE’,
‘Volume Down’ and ‘Volume Up’ buttons to select or
de-select.the.various.bands..Note.that.Laser.detection.
cannot.be.turned.off.
If.you.want.to.just.use.the.BTST.as.a.Laser.detector.(for.
mobile.speed.traps.only),.then.just.turn.all.Radar.bands.off..
Once you have made your selections, press the ‘CITY’
button.again.to.select.which.tones.you.would.like..
Use the ‘MUTE’, ‘Volume Down’ and ‘Volume Up’
buttons.to.select.Tone.set.I,.II.or.III.
CITY
MUTE X/Ku.ON/OFF

K.ON/OFF

Ka.ON/OFF
CITY
MUTE Tone.I

Tone.II

Tone.III
Once you have chosen, press the ‘PWR’ button to
return.to.normal.mode.
TEST
To.test.the.tone.and.display.for.each.band,.hold.down.
the ‘CITY’ and ‘MUTE’ buttons simultaneously for 2