background image

408-2363

4 of 4

Rev J

2. Close the tool handles until the ratchet releases 
then allow handles to open freely, and observe the 
following:

a. Handles open before the ratchet hits the 
dowel pin.

b. Jaws grasp the NO-GO element.

If above conditions are met, the ratchet is 
performing satisfactorily. If not, see Section 5, 
REPLACEMENT AND REPAIR.

3. Re-install the dies, and secure them with the roll 
pins.

5. REPLACEMENT AND REPAIR

Customer-replaceable parts are listed in Figure 6. A 
complete inventory should be stocked and controlled 
to prevent lost time when replacement of parts is 
necessary. Parts other than those listed should be 

replaced by TE Connectivity to ensure quality and 
reliability. Order replacement parts through your 
representative, or call 1-800-526-5142, or send a 
facsimile of your purchase order to 717-986-7605, or 
write to:

CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608

For customer repair service, contact a representative 
at 1-800-526-5136.

6. REVISION SUMMARY

Since the previous revision of this document, the 
following changes were made:

Updated dimension in table in Figure 5

Figure 6

REPLACEMENT PARTS

ITEM

PART NUMBER

DESCRIPTION

QTY PER TOOL

1

21045-3

RING, Retaining

4

2

1-23619-6

PIN, Retaining

2

3

2-23620-9

PIN, Retaining

1

4

21045-6

RING, Retaining

2

5

39364

SPRING

1

6

1-21919-1

PIN, Dowel

1

7

6-21028-8

PIN, Roll

2

8

305956-8

ANVIL, Die

2

63.5 [2.50]

12.7 [.50]

279 [11]

Weight 404 g [13 oz]

1

2

3

4

5

6

7

8

Reviews: