Raychem Devices
No: RCPS-200-20
Rev: E1
Date: August 10, 2016
Installation Procedures for D-436-XX and D-200-XX
(Miniseal™) Sealed Crimp Splices
_________________________________________
Unless otherwise specified dimensions are in millimeters. [Inches dimensions are in between brackets]
© 2007-2016 TE Connectivity Corporation. All rights reserved.
If this document is printed it becomes uncontrolled. Check for the latest revision.
(2) If directed in the splicing tables to fold any conductors back, fold the appropriate
conductor(s) as shown below.
5.3
One-to-one In-line Splices and Two-wire Stub Splices
5.3.1
Select proper slice components and prepare the wires as shown. (See 5.0.1, 5.0.2)
5.3.2.
Splicing Procedure
(1) If making an in-line splice, slide the sealing sleeve onto either wire.
For stub splices, the sealing sleeve will be installed later.
(2) Crimp the wires in the crimp splice as shown in the appropriate figure below.
The gap between the end of the wire insulation and the crimp splice must be
0.8 - 1.6 mm (1/32 - 1/16 inch).
(3) Center the sealing sleeve over the splice area as shown.
