408-35328
Rev
A
4
of 7
4 Crimping
For strip length and specific crimp information for each terminal being crimped using this die assembly, refer to
the application specification listed in Table 1.
CAUTION
If the tool holder is equipped with a crimp height (fine adjust) adjustment, you can avoid damage to the terminator, modular
tool holder, or die assembly by starting at setting A on the crimp disc and incrementally adjusting to the specified crimp height.
If the machine has crimp height/shut height adjustment, refer to the applicable 412 series customer manual for guidance.
1. Assemble the ferrule to the prepared wire assembly according to the 114 series application
specification listed in Table 1.
2. Open the wire clamp by pressing down on the lever (Figure 3).
3. Insert the prepared assembly into the crimping die (Figure 4).
Figure 4: Inserting the assembly into the crimping die
