412-10100
Rev A
20
of 74
3.4.3 Force Sensor Tab
Touch the Force Sensor tab (Figure 10) to select the force sensor that is installed on the terminating machine.
The options are are
Piezo Frame
and
Strain Gauge
(base plate).
Figure 10: Force Sensor tab
3.4.4 Sensor Calibration Tab
If you have the Analog Height sensor, then you must calibrate it. Touch the Sensor Calibration tab (Figure 11),
follow the instructions on the display, and enter the low and high voltages that you measured based on the
switch settings of the A/D Calibration Switch. A TE A/D Calibration Switch and a digital voltmeter are required
to perform this calibration.
Figure 11: Sensor Calibration Tab
