409-35001
Rev C
10
of 92
5. If the head
will never
move from left to right, then install the monitor on the shelf. Avoid hitting the pivot
handle (see Figure 7 below). If the head
will
be moving, then place the monitor on the table top next to
the machine. This way, the pivot handle can be easily reached and moved as necessary.
Figure 7
6. Reinstall monitor power cord and monitor video cable.
7. Place keyboard and mouse in keyboard tray and connect to the UI computer on the electrical panel.
8. Connect Barcode Reader (if supplied).
9. Remove press head lock-down brackets, if installed.
10. Power up press by turning on Master Power Switch. The system will boot to the home screen. The
default username
Administrator
has a default password of
administrator
.
NOTE
Administrator (Customer / Owner) should change the initial login password to secure the machine from unauthorized access.
Facilities Labeling
The machine part number, serial number, manufacture date, and electrical specification are given on the
label on the left side of the machine as shown in Figure 8.
Figure 8
Electric Supply Circuit
Electrical supply circuit must be 200-240VAC, 50/60 Hz, single phase.
Pneumatic Supply
The pneumatic supply must be connected to the port provided in the Foot Switch. Compressed air is used
only for the optional Air Table. Air consumption is minimal. Pressure for the Air Table should be set to the
minimum necessary to “float” the PCB fixture use
d.
