Application Specification
AMP- LATCH*
Universal Headers
114--40020
LOC B
1
of 9
E
2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
TE logo is a trademark.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
www.te.com
with ACTION PIN* Contacts
19 DEC 11 Rev D
All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and
inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2
_
.
Figures and illustrations are for identification only and are not drawn to scale.
1. INTRODUCTION
This specification covers the requirements for application of AMP--LATCH Universal Headers with ACTION PIN
Contacts. The headers are available in various positions from 10 through 64. These headers are mounted on a
printed circuit (pc) board by a seating tool which uses various power units for application. The headers are
available with short or long tail contacts and optional ejector latches.
Figure 1 provides contact features and terms used throughout this specification. Use these terms when
corresponding with TE Connectivity Representatives to facilitate assistance.
Figure 1
Polarization Slot
Header Assembly
Mating End
Termination End
ACTION PIN
Contacts
Ejector Latch
(Optional)
Housing with Universal
Polarizing Slots
V--Shaped Indicator
for No. 1 Position
2. REFERENCE MATERIAL
2.1. Revision Summary
This paragraph is reserved for a revision summary covering the most recent additions and changes made to
this specification which include the following:
S
Updated document to corporate requirements
S
Added new table to Figure 3
2.2. Customer Assistance
Reference Part Number 499582 and Product Code 5275 are representative numbers of AMP--LATCH
Universal Headers with ACTION PIN Contacts. Use of these numbers will identify the product line and expedite
your inquiries through a service network established to help you obtain product and tooling information. Such
information can be obtained through a local TE Representative or, after purchase, by calling the Tooling
Assistance Center or the Product Information number at the bottom of this page.
2.3. Drawings
Customer Drawings for each product part number are available from the service network. The information
contained in Customer Drawings takes priority if there is a conflict with this specification or with any technical
documentation supplied by TE.
NOTE
i
