© 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1
of 4
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
www.te.com
LOC B
408-9657
75-Ohm Hex Crimp
Die Assemblies
58425-[ ] and 58436-[ ]
14 OCT 11 Rev E
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Figure 1
1. INTRODUCTION
This instruction sheet covers the use and maintenance
of Crimping Dies 58425-[ ] and58436-[ ] (in their
various configurations - denoted by the dash number
following the base part number), used in PRO-
CRIMPER III Hand Tool Frame 354940-1. The dies
crimp 75-Ohm Hex Crimp BNC and TNC plug
connectors onto coaxial cable.
Reasons for reissue of this sheet are provided in
Section 7, REVISION SUMMARY.
NOTE
i
All dimensions are in millimeters [with inches in
brackets]. Figures and illustrations are for
reference only and are not drawn to scale.
2. DESCRIPTION
(Figure 1
)
Each die assembly consists of an indenter die and an
anvil die. When closed, the dies form either two or
three crimping chambers (depending on type) which
crimp the center contact and ferrule of the connector
onto the coaxial cable. Each die is held in the tool by a
single screw.
3. DIE INSTALLATION
1. Close the tool handles until the ratchet releases
and then allow them to open fully.
2. See Figure 1 for normal orientation of the dies.
Insert the dies inside the tool jaws and align the
retaining screw holes.
3. Thread the retaining screws into the holes and
carefully close the tool handles. Tighten the screws
with the appropriate hex wrench.
Anvil Die
Stationary Jaw
Hand Tool Frame
354940-1
Die Assemblies 58425-[ ]
and 58436-[ ]
Indenter Die
Moving Jaw
