409-32031
Rev D
6
of 9
Pressure Sensor
The tool is equipped with a pressure sensor that alerts the user of an incomplete crimp.
If the tool is manually retracted before completion of a crimp, the red LED will flash for two seconds
and an audible alarm will sound for two seconds.
If the tool is unable to reach the required crimp force, the red LED will flash for two seconds and an
audible alarm will sound until after the trigger is released.
NOTE
The tool has an on-board memory of previous crimp cycles and the cycle count. This information can be accessed and
downloaded onto a computer using USB Adapter Module 2217896-1.
OPERATION
Battery Installation and Removal
NOTE
The batteries Directive 2006/66/EC introduces new requirements from September 2008 on removability of batteries from
waste equipment in EU Member States. To comply with this Directive, this device is designed to allow the rechargeable
battery pack to be easily removed by the end-user when it needs to be replaced.
To install the battery, slide the battery into the bottom of the crimping tool until it can go no further. There will be
an audible “click” from the battery lock to indicate that the battery has been properly installed.
To remove the battery, disengage the battery lock by applying pressure on the lock toward the bottom of the
crimping tool and slide the battery away from the tool.
DANGER
Always dispose of the old battery pack in an environmentally-responsible way, in accordance with local waste regulations.
Where possible, please recycle the battery cartridge. Contact your local authority for details of battery recycling locations in
your area.
Die Assembly Installation and Removal
DANGER
To avoid personal injury, be sure to exercise extreme caution when handling the crimping tool. Remove the battery before
installing or removing the die assembly.
Each kit is supplied with an SDE crimping head installed on the battery-powered crimping tool. The only
installation required is the die assembly.
CAUTION
Do not operate the tool without the SDE crimping head installed. Damage to the ram or seals can result.
CAUTION
Do not operate the tool without the die assembly installed. Damage to the crimping head can result.
The following instructions are specific to the use of TE SDE die assemblies. Make sure to use only TE SDE die
assemblies.
Installation
1. Remove the battery from the crimping tool.
2. Remove the two die retaining screws from the crimping head.
3. Slide the upper die into the stationary jaw of the crimping head. Orient the upper die so that the
indenters face inward, with the largest indenter entering first, and the screw holes align. See Figure 4.
4. Insert the upper die retaining screw into the screw hole of the stationary jaw and through the screw
hole of the upper die. Tighten the screw just enough to hold the die in place. Do NOT tighten the
screw completely at this time.
Greenlee is a trademark.