409- 10058
Rev E
6
of 8
3.1. Die Set Installation
(Figure 3 )
If dies to be installed in the tool require insulation adjustment, refer to the instruction sheet packaged with the
dies for adjustment, then proceed as follows:
1. Remove the battery from the tool.
2. Mate the die assembly and insert it into the tool yoke. See Figure 3.
3. Position the stationary die in the stationary die holder. Turn the die retaining screw sufficiently to hold
the die in place. Do not tighten the screw.
4. Position the moving die in the moving die holder. Turn the die retaining screw sufficiently to hold the
die in place. Do not tighten the screw.
5. Replace the battery and check the alignment by pulsing the trigger to (slowly) close the dies, making
sure the anvil and indenter are properly aligned.
6. With the dies closed, tighten the die retaining screws.
Figure 3
Moving
Die
Color Code
Stationary
Die
Locator
Die Retaining Screw
Dies Installed in Tool Yoke
3.2. Die Set Removal
To remove or change the dies, simply loosen the die retaining screws and remove the dies.
4. OPERATION
4.1. Battery Installation and Removal (Refer to Figure 1)
The Batteries Directive 2006/66/EC introduces new requirements from September 2008 on removability of batteries
from waste equipment in EU Member States. To comply with this Directive, this device is designed to allow the
rechargeable battery pack to be easily removed by the end--user when it needs to be replaced.
To install the battery, slide the battery into the bottom of the crimp tool until it can go no further. There will be an
audible “click” of the battery lock to indicate that the battery has been properly installed.
To remove the battery, disengage the battery lock by applying pressure on the lock toward the bottom of the
tool and slide the battery away from the tool.
Always dispose of the old battery pack in an environmentally--responsible way, in accordance with local waste
regulations. Where possible, please recycle the battery cartridge. Contact your local authority for details of battery
recycling locations in your area.
4.2. Crimping
The following procedure provides only general information concerning crimping. Refer to the instructions
packaged with the dies for detailed information, including wire stripping dimensions and instructions for
positioning terminals and splices in the dies.
NOTE
i
DANGER
