4 |
P a g e
10.
Once you have secured the jumping mat
with a spring spaced out every 5
th
hole,
start again by placing a spring to the
right of each of the 1
st
round of springs.
** Continue this process until all springs are
attached.
**TIP:
This process is necessary to ensure you do
not overstretch the springs during installation.
11.
With the springs installed- you are ready
for the installation of the Vented Safety
pad beginning with step 12.
**Note
: If you have purchased our optional
Enclosure Net system- you will at this point begin
installation of the Net base poles onto the frame of
the Trampoline prior to moving on to step 12.
12.
Begin by laying out the vented safety
pad on top of the springs of the
Trampoline. Line up the receiving
buckle on the pad with the previously
installed buckle clip on the frame (from
step 6) and lift the pad to locate and
remove a spring that lines up with the
front and center Spring loops- thread the
spring through the loops and re-secure to
the frame.
Complete this process for each pad section.
**Note: There are 8 front loops, and 8 rear loops to
thread springs through.
13.
With all the spring loops secured- you
are now ready to finish the installation
by clicking the pad buckle together at all
8 sections.
