©Total Disc Repair Ltd | www.totaldiscrepair.co.uk | Technical Support: 0800 412 5424 - [email protected] | Sales: 01202 489 500 - [email protected]
Getting To Know The Machine
Topping up polish and water
Priming the pumps
Polish supply
On the back of the machine is a small
bottle which contains a thick white
polish. Ensure that this bottle is at
least 1/3 full before operation.
Make sure that the tube inside the
bottle reaches the bottom of the
bottle. The bottle feeds polish to the
pump marked with a blue dot.
Water supply
In each cycle the machine uses
water as a coolant and to remove
the waste product. Added to the
water is a small amount of additive
which helps with the process.
Using the syringe supplied add 5ml of additive for
every 1 litre of water in the container. (if you are
filing the bottle from empty add 20ml of additive and
fill the bottle to the 4 litre line).
For best results use mineral or deionised water.
Coming from the pump with the red dot will be a long
tube with a stone filter on the end. Feed the tube in
to the top of the water bottle ensuring that the stone
filter reaches the bottom of the bottle.
Step 1 - Preparation
1. When priming pumps place a tissue under the drip
feeds as shown to stop the turntable getting wet.
Step 2 – Pump operation mode
Waste collection
Ensure that the tube coming from the front of the
machine has a clear run to the waste bottle otherwise
the waste could back up. You should cut down the
waste tube so that it does not sag or kink.
Empty the waste bottle every time you fill the water
bottle.
Your machine will have already arrived with the polish
and water pumps primed and ready to go. However it
is important to understand how to do this yourself.
2. Press and hold MODE/STOP and ‘5’ at the same
time. A ‘P’ will appear in the ‘ST’ display.
3. To exit this mode press MODE/STOP.
4. Once you are in Pump Operation Mode it is simple
to prime each pump.
5. Press ‘1’ again to stop the pump when you see
water coming out of the drip feed.
If you are not going to use the machine for a while it
is important to clear the polish tube of polish so that
it doesn’t dry in the tube.
6. Press ‘2’ again to stop the pump when you see
polish coming out of the drip feed.
Press ‘3’ to start this process. It will return all of the
polish in the tube back to the bottle. Press ‘3’ again
to stop the pump.
Step 3 – Priming the water (Press 1)
Step 4 – Priming the polish (Press 2)
Clearing the polish tube
4ltr
20ml
