AN-000227
Document Number: AN-000227
Page 7 of 15
Revision: 1.0
PROGRAMMING THE SMARTSONIC BOARD
•
Setup SmartSonic board Jumper J1 as in Figure 1. If only one cable is used (connected to the EDBG port),
pins 3 & 4 should be shorted.
•
Connect the SmartSonic board to a Windows PC with EDBG USB cable.
•
In Atmel Studio 7 select
Tools > Device Programming
.
•
The Device Programming screen will appear:
Figure 2. Device Programming Screen
•
Verify that the tool is
EDBG
, device is
ATSAMG55J19
, and interface is
SWD
.
•
Select
Apply
.
o
Note
: Atmel Studio 7 may require you to update the EDBG debug interface firmware on the
SmartSonic board before continuing. Follow the on-screen instructions to update the EDBG
firmware.
•
The Device Programming screen will prompt to set the programming clock frequency. Leave the clock
frequency unchanged (use the default).
•
Select
Read
near the
Device signature
field. The device signature bytes should be read and should not
generate any error messages. The Device programming menu should look as follows:
