AN-000227
Document Number: AN-000227
Page 4 of 15
Revision: 1.0
INSTALLATION / PREPARATION
•
Download and install Atmel Studio 7 IDE.
•
Download and install (unzip) the SmartSonic_Presence application to a project directory of your choice.
•
Install terminal emulator.
•
Connect the Chirp sensor daughterboard to the SmartSonic board. Be careful to align the white arrows.
•
Optional:
Using flat flex cables, attach additional off-board sensor(s) to the connectors on the
daughterboard. If an offboard sensor is connected to the Sensor 0 connector (J6), you must set the switch
on the side of the daughterboard to use the off-board sensor as Sensor 0 instead of the sensor on the
daughterboard.
•
Connect the SmartSonic board to a Windows PC with the USB cable. Configure the jumpers on the board
as shown in the following photo with J1 in EDBG USB mode (short 3-4)
Figure 1. SmartSonic with CH201 Daughter Board
