EZA2500 Series
TDK-Lambda
<Page>
1
2
3
With Charging mode
With Discharging mode
OFF
OFF
OFF
OFF
OFF
ON
Manual Battery CV
Manual Grid CV
OFF
ON
OFF
OFF
ON
ON
ON
OFF
OFF
Manual Battery CV
Automatic Grid CV
ON
OFF
ON
Manual Battery CV
Manual Grid CV with Battery CC
ON
ON
OFF
Manual Battery CV
Automatic Grid CV with Battery CC
ON
ON
ON
4
5
OFF
OFF
OFF
ON
ON
OFF
ON
ON
6
7
8
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
ON
ON
OFF
OFF
ON
OFF
ON
ON
ON
OFF
ON
ON
ON
DIP SW
DIP SW
RS485 Baud rate *
2
DIP SW
RS485 Address Area *
2
19.2kbps
9600bps
Reserved
Automatic Battery CV
6 : 0x60 - 0x6E
7 : 0x70 - 0x7E
Operating Mode
Invalid *1
Reserved
38.4kbps
57.6kbps
0 : 0x00 - 0x0E
1 : 0x10 - 0x1E
2 : 0x20 - 0x2E
3 : 0x30 - 0x3E
4 : 0x40 - 0x4E
5 : 0x50 - 0x5E
8. User Interface
The front panel of this converter has a tact switch, rotary switch and 3 LEDs.
Also the rear panel has an 8-bit DIP switch.
8-1. Tact SW
The tact switch functions as alarm clear button when the alarm is activated due to abnormal occurrence.
When this switch is pushed, a command to clear the alarm is sent to the converter while in alarm state
(ALM LED ON).
This switch does not function when converter is not alarm state.
8-2. Rotary SW
The rotary switch functions as the RS-485 address setting for this converter.
The interface address is composed of 7 bits and can be set within the range "0x00"
I
"0x7E" range.
Rotary switch is used to set the lowest digits (last 4 bits) and DIP SW is used to set the highest digits.
Note: The last digit address "F" is a reserved address for broadcast address and must not be used for
setting address.
The value pointed by the arrow of the switch is recognized as the lowest digits of the interface address.
t
0x00
t _i Z [ \W k bj lW bk [ W j
the time of factory shipment.
The value of the rotary switch is only recognized at the startup the control circuit in the converter (interface
MCU initialization). If the settings are changed during converter operation, the changed setting becomes valid at
the start of the next startup the control circuit in this converter.
8-3. DIP SW
DIP Switch functions as a setting switch to designate operating mode of this converter.
DIP switch is turned ON when the lever is pressed down.
-
,
#
$
%
&
'
(
)
*
*1 Operate by RS485 Communication only
*2
The value of the DIP Switch is only recognized at the startup the control circuit in the converter during
interface MCU initialization. If the settings are changed during converter operation then the changed
settings become valid at the next start up control circuit.
10/22
