TDC 80808 Instructions Manual Download Page 4

Pop Up Gazebo

Pop Up Gazebo

 

 

 

 

 

     Item #80808, 88938, & 88939

Item #80808, 88938, & 88939 

 

      

Customer 

Service 

      

1-800-599-8898

Customer 

Service 

      

1-800-599-8898

Before starting assembly, find a flat level work area.  The assembled 
gazebo is 10’ x 10’.  Allow sufficient working room for the assembly.

Important: Use caution when opening or closing the gazebo to avoid 
damaging the frame.

Gradually pull each corner of the gazebo outward to extend the frame 
fully on all sides.  Four people are recommended in assembling the 
gazebo.  Holding a gazebo leg, each person should extend the frame 
outward a little or until a small amount of resistance is felt.  Do not 
pull the frame out too much at any one time as this may cause damage 
to the frame.  Keep moving outward until the frame is fully extended. 

Unfold the fabric canopy pack, place the fabric top over the top frame. 
Use the velcro pads to secure each corner of the cover to the corner of 
the frame.

With each person holding a gazebo leg in one hand, slide each roof 
support upward until it locks into place on the pin near the top of the 
leg. If you have difficulty moving the roof supports up, make sure the 
gazebo frame is fully extended.

Each person should slide the top leg section upward to the 
lowest height setting.  The locking pin must engage the top hole 
completely to prevent the leg from collapsing.  Adjust all four legs.  
Now select from the three leg heights available.  Make sure all four 
legs are the same height.  See picture for maximum height 
setting.

 

Assembly Instructions

Assembly Instructions

Reviews: