TDC USA 21944, Instructions Manual

Page: 3 / 7

7 Piece Dining Set - Table Assembly
4 Item #21944
7 Piece Dining Set - Table Assembly
Item #21944 5
Customer Service 1-800-599-8898 Customer Service 1-800-599-8898
E
E
G
G
Fig. 1
Fig. 2
B
B
B
B
A
C
C
E
E
G
G
Assembly Instructions
Step 2:
Assembly Instructions
Place Leg Brace (D) in between Crescent Legs (B) and Arches (C). Insert two Screws
1/4”x25mm (F) with Washers (G) through the corners of Leg Brace (D) and into
Crescent Legs (B) {see fig. 3}. Tighten screws enough to hold these two parts together.
Follow these steps to connect all corners of Leg Brace (D) with the Crescent Legs (B).
Insert two Screws 1/4”x16mm (E) with Washers (G) through Arch (C) and into Leg
Brace (D) {see fig. 4}. Follow this step to connect the additional Arch (C) with Leg Brace
(D). Tighten all screws that have been left loose throughout the building process.
Step 1:
Set the Table (A) upside down so that the screw holes on the table rim are right-side
up. Insert two Screws 1/4”x16mm (E) with Washers (G) through screw holes at the
end of the crescent of a Crescent Leg (B) {see fig. 2} and into the corners of rim of
Table (A). It is advised to keep all parts loose until assembly is complete. Follow these
steps for the three remaining Crescent Legs (B) at each corner of the Table (A).
Insert two Screws 1/4”x16mm (E) with Washers (G) through screw holes at the top
end of Arch (C) {see fig. 1} and into the center of rim of Table (A). Follow this step to
mount the additional Arch (C) on the opposite side of the table rim.
Step 1:
Fig. 3
B
Fig. 2
Fig. 4
B
B
B
A
C
D
E
G
F
F
G
G