TCS FBI4500-0100, Product Information

Page: 7 / 16

11/2012 7
TCS TürControlSysteme AG

TCS Hotline: +49 (0) 41 94 / 98 81 188 Subject to technical changes.
FAX: +49 (0) 41 94 / 98 81 29

Mail: hotline@tcsag.de PI_FBI4500-0100.doc 2A
Installation
Installation location

The PTZ camera interface is suitable for the inner and outer installation
(housing IP65).
!

When installing the device outdoors, please observe that the cable gland (M12
screw connection) must be facing downwards!

Please observe the documentation of the camera manufacturer !
Open and close the housing

Loosen the cover screws of the PTZ camera interface. Remove the cover.

Use the lower cover to mark out the four attachment holes at the corners of the housing.
!
Do not use the lower cover as drilling template as it may cause damage to the de-
vice!

Drill the marked holes and insert dowels into the wall if necessary. Screw the housing
firmly to the wall.

Guide the connection lines through the cable gland (M12 screws).

Close the housing only after the installation and configuration.
Connect the lines
Connection lines
The connection of the connection line is attained by a M12 screw connection.

Use only one cable with jacket, diameter 3.5 to 7 mm per screw connection.

Cross-sections for connection lines
Connection TCS:BUS
Permitted cross-section (diameter)
Max. number of wires per terminal contact
Connections camera
Permitted cross-section (diameter)
Max. number of wires per terminal contact
0.32
… 2.1 mm
2
(Ø 0
.3 … 1.6 mm)
each 2 x Ø 0.8 mm or 3 x Ø 0.6 mm
0.08
… 1.3 mm
2
(Ø 0.32
… 1.3 mm)
each 2 x Ø 0.8 mm or 3 x Ø 0.6 mm