Page 33
Panel buttons
The controls on the TV enable you to perform simple functions, but are not a substitute for
the remote control. The joystick-‐type control on the back of your TV near the lower right
side provides the following functions:
•
Press in to toggle between power ON and Standby.
•
Press up or down to increase/decrease the volume.
•
Press left or right to switch inputs.
Standby mode energy savings
When you turn off your TV, it may remain in a higher power mode for a few minutes, after which it goes
into a very low power standby mode. If you turn on the TV again before it has entered the very low
power mode, it turns on immediately. After the TV goes into the lower power standby mode, it takes a
bit longer to start up.
Watching broadcast TV channels
To watch broadcast TV, select the
Antenna TV
tile in the
Home
screen. Your TV remembers the last
channel you watched and starts with that channel playing.
Tip
:
You also can use the buttons on the TV panel to select Antenna TV, as explained in "
Panel
buttons
” on page
33
.
Changing channels
To change channels, you can do any of the following:
•
Press the
UP
arrow to change to the next higher channel.
•
Press the
DOWN
arrow to change to the next lower channel.
•
Press the
LEFT
arrow to display the channel list, and then press the
UP
and
DOWN
arrows to
move the highlight through the list one channel at a time. Or press
REWIND
and
FAST
FORWARD
to move the highlight through the list one page at a time. When you’ve highlighted
