Tchibo Cafissimo Pure, User Manual And Warranty

Page: 9 / 15

9
crema (yellow cup) and filter coffee (blue cup).
Proceed in the same way as for brewing coffee: Fill the water tank, insert a 1.
capsule and place a cup beneath the spout.
Press and hold the relevant coffee button until the required quantity of coffee 2.
has been dispensed into the cup.
When you release the button, the machine will save that quantity. 3.
If the settings are not to your taste, simply repeat the procedure to change them
again.
Restoring the factory settings
You can restore the original settings for the water quantity.
1. Press the On/Off switch to switch off the machine.
2. Press and hold the left and right
coffee buttons and switch the
machine on.
3. Release the buttons.
The factory settings for the water quantity have been restored.
Releasing pressure
Always fold back the lever after each brewing proce-
dure. The capsule will fall out and the pressure in the
system will subside.
Fold the lever down again when you are not using the
machine in order to close the capsule compartment.
7. After use...
... empty the water in the drip tray. Due to how the machine operates there will
always be water and a small residue of coffee grounds collected in the tray.
... empty the used capsule container daily or whenever it is full.
Approx. 8 capsules fit inside.
Always remove used capsules from the machine. Empty out the used
capsules daily. In case you forget a capsule in the machine for a few days,
rinse the machine as described in the section “Rinsing the machine”.
Adjusting the strength of the coffee
Adjust the strength of the coffee to suit your personal taste by adjusting the
quantity of water. You can do this for one single brewing procedure or save the
setting.
Adjusting the strength for the current brewing procedure (without saving
the setting)
If the coffee is too weak , you can stop the water flow prematurely by
m
pressing the flashing coffee button.
If the coffee is too strong , start the brewing procedure again without
m
inserting a new capsule. Press the button as soon as sufficient water has
run through.
Setting the strength permanently (saving the setting)
You can change the factory settings for the water flow permanently. This enables
you to make your favourite coffee every time at exactly the strength you prefer.
You can customise the setting for each type of coffee: espresso (white cup), caffè
Default settings (amounts are approximate):
Espresso 40 ml I Caffè crema 125 ml I Filter coffee 125 ml
The water quantity can be set to between approx. 30 and 300 ml.