First Setup and Use
1. Turn down your PA’s master volume.
2. Connect your mic and PA as shown in the diagram first, then plug in the AC adaptor. For live
performance, a USB connection to a computer is not required.
3. Set the style to Tight and the mix control to the center notch.
4. Sing into your mic while adjusting the MIC GAIN control so that the input level LED flashes green.
Brief flashes of red on the LED on your loudest singing are ok.
5. Ensure that the effect is on (center LED is lit).
6. Sing while turning up your PA volume to a comfortable level.
You can now sing while you sample the different doubling styles and raise and lower the mix. You’re
ready to perform! Note that When the effect is on, your dry voice is slightly delayed to align best with
the double voices and increase realism for your audience.
Phantom Power
There is no switch to enable phantom power on the VoiceTone singles. Phantom power is available
when the product is powered. Microphones that don’t require phantom power will operate properly.
Always apply power as the last connection step and ensure your PA is muted. This will reduce the
chance of audio pops that could harm your equipment.