5
Harmony Singer 2 User Manual
•
Connect a microphone to the MIC jack
•
Connect the OUT jack to a mixer, interface or active speaker
•
Connect a guitar to the Guitar Input jack on the right side of the pedal
•
Connect the left Guitar Output jack to an amplifier or mixing console
Optional:
•
Connect a micro USB cable to a computer
•
Connect power cable
•
Using the Harmony Knob
The Harmony knob selects a single harmony voice or combination of voices
higher or lower in pitch than your voice. The chart below shows name and pitch
intervals for each position on the Harmony knob.
Guitar Input
Connect any guitar pedals between Harmony Singer’s Guitar Output jack and
the input of your amp. Connecting and activating some guitar pedals before the
Guitar Input jack may adversely affect vocal harmony production.
Tips:
•
Strumming chords works better than single note playing for
harmony control
•
When changing chords, ensure that the root and 3rd of each
new chord are played clearly
•
To harmonize correctly from the first chord of a song,
briefly play the first chord before singing
Momentary Mode
The standard function of the footswitch is a latching style, meaning that each
press of the footswitch turns the harmony on and off. Alternatively, the pedal can
operate in momentary mode, meaning that the harmony is only active while the
footswitch is held down. As soon as you release the footswitch,
the harmony is bypassed.
To switch the unit to momentary mode, hold the Tone button down while
powering the unit on. Repeat the process to return to latching mode.
Changing the Batteries
Harmony Singer 2 can operate on 4 AA batteries. Remove the single screw on
the bottom of the pedal to open the battery door. Make sure to observe correct
polarity when inserting the batteries.
Auto Gain
Harmony Singer 2 will automatically adjust the gain setting for your microphone,
eliminating the need for manual adjustments and ensuring that a good signal is
passed to the mixer without any unwanted distortion.
24 V Phantom Power
Phantom power is always active on the Harmony Singer 2. This will power
condenser microphones, but will not affect dynamic mics either.
Mic Control
Mic Control allows you to control the effect's on/off status via an
MP-75 microphone. Press and hold the footswitch while powering up the unit
to toggle Mic Control.
Note that when using a condenser microphone, Mic Control should be disabled to
prevent unwanted on/off switching.
Icon
Name
Interval
High
3rd above
Higher
5th above
High and Higher
3rd above
5th above
Low
4th below
Lower
6th below
Low and Lower
4th below
6th below
Higher and Lower
5th above
6th below
High and Low
3rd above
4th below
Summary of Contents for HARMONY SINGER 2
Page 7: ...7 Harmony Singer 2 User Manual ...
Page 8: ......
