- 22 -
(Note: Please contact your local network administrator for your network settings.)
Local Description
(not require): Enter the description for the local unit.
IP Address:
Unit's IP Address. The default IP Address for Master is 192.168.254.123, and the
default IP Address for Slaves is 192.168.254.124.
If you change the IP Address, you must reconnect using the new IP Address. If you are
using the DHCP* option, this value will be set automatically.
Subnet Mask:
This indicates the TCP/IP network class you are using.
The default Subnet Mask is 255.255.255.0. If you are using the DHCP* option, this value
will be set automatically.
Master Description
: Enter the description for the remote unit.
Master IP Address:
(not require for Master unit.) For Slave units, this is the IP Address of the remote
Master. Logical name is also supported if DNS is setup.
Important:
This Master IP address on the Slave units must match to the IP address of the
Master unit.
Multicast IP Address:
The IPv4 networking standard defines Class D addresses as reserved for
multicast.
Multicast IP addresses are in the range of 224.0.0.0 through 239.255.255.255.
The Default value for Multicast IP Address is 239.192.0.1
(Note: Please contact your local network administrator for your network. Master and slaves’
multicast IP Address setting must be the same.)
UDP Port Number
:
Two UDP Ports are used by TC3420 communication. (Note: Master and slaves’
UDP port settings must be the same.)
UDP Port Number One:
The Master unit uses UDP Port One to transmit (Multicast).
The Slave units use UDP Port Ont to receive.
UDP Port Number Two:
The Master unit uses UDP Port Two to receive.
Slave units use UDP Port Two to transmit.
Gateway Address:
If your connection contains a router, enter the IP Address of the Router (LAN
side.)
Default value is 0.0.0.0 If you are using the DHCP* option, this value will
be set automatically.
DNS Address:
Domain Name Server. If you need to connect outside of your LAN, enter the
DNS IP address here.
Defaultvalue is 0.0.0.0 If you are using the DHCP* option, this value will be set
automatically.
*
Note:
Not used, for future release.
