5
|
P a g e
Button SPEED:
The default function is to select different available counting speeds.
Button ↑:
This button is used to move up the cursor or adjust number magnitude in batch setting mode.
Button ←:
The default function is to move the cursor left. When in batch setting mode it chooses the number
digits.
Button →:
The default function is to move the cursor right. But when in batch setting mode it chooses the
number digits. And this button also supports to get in the setting menu when in the main interface.
Button ↓:
The default function is to move cursor downwards. Adjust number magnitude in batch setting mode.
ADD/DISP
: The default function is to switch on/off ADD function.
Button ESC
: The default function is to clear the input or back to upper level.
Button PRINT
: The default function is to work as a OK or CONFIRMATION. When you press REPORT to check the
counting detail and your value counter is connected with a printer, then in REPORT mode, press this button to print
out the detail.
Button START/RESET
: This button is used to start counting, or back to upper level in MENU.
4.
Operation Modes
4.1
CNT mode
Press button MODE to select CNT mode. In this mode, you can switch on ADD or BATCH or ADD+BATCH.
4.2
SDC mode
Press button MODE to select SDC mode. This mode is to count a single denomination bill.
The system will take the first note as the benchmark, and will stop counting when meeting a different
denomination.
4.3
MDC mode
Press button MODE to select MDC model. This mode is a value counting mode for mixed denominations, and press
REPORT button to check the counting details.
5.
Maintenance and notice
5.1
In order to make sure count display and person safety, you must install good grounding when to use. Safe
pip rated value is “2A”, not too much.
5.2
Please turn off the machine and unplug the power cord when close every day. To clean the sensors
(note-feeding sensor, note-receiving sensor and counting sensors) softly with brush, If meet with trouble,
please ask for repairman to check and repair.
5.3
The time between open and close should be over 5 seconds, to avoid the number of display window being
disturbed.
