(C) TBProAudio 2018
Page 8 of 9
6.6.10.1
Auto Release
Release time is calculated program dependant, 125dB/s
6.6.11
Makeup Gain
Adjust the output level of the compressor in dB, -24dB - +24dB, in 0.1dB steps
6.6.11.1
Auto Makeup Gain (AMG)
If switched on makeup gain is calculated ratio dependant
6.6.11.2
Set Makeup Gain
Sets makeup gain so that output level reaches 0dBFS. Hold shift key to reach -0.1dBFS
6.6.12
Dry/Wet
This control mixes the dry signal with the wet (compressed) signal, 0 (dry) - 100 (wet)
6.6.13
Look Ahead
Main/Detector signal is "pre-delayed" in order to let compression start "earlier", 0 ms - 3000
ms, in 0.001ms steps
6.6.14
Max Gr
Limit maximum gain reduction. This is very useful for vocal compression, just to avoid over
compression.
-96 - 0dB, in 0.1dB steps
6.7 Meter
Meters for main signal (Inp), detector signal (Det), output
(Out) and gain reduction (GR).
LED signal meter range is from -60dBFS to +12dBFS, in 3dB
steps.
LED gain reduction meter is from -60dB to 0dB, in 3dB steps.
Value below meters show maximum value.
If signal clips (above 0dBFS) top LED lights red.
Click on the meter resets max. values and heat-maps in the
scope display.
6.8 Scope
6.8.1 Gain Transfer Graph
This display show the current gain transfer curve (white line),
current threshold value (blue line), maximum main signal
level (red area) and current main signal level (light red area).
Additionally heat-maps of main signal (top) and output signal
(right) are shown
